Viatron AA800EZe Manual de usuario descargar pdf (Pagina 20)

20

AA800EZe rev.04

AA800EZe

Phone Numbers4.4.

The Agri-Alert uses the phone numbers to

report alarm conditions. It can either send

the alarm condition by means of a voice

message or on a pager. The order in which

phone numbers are stored defines the order

of the dialout sequence, i.e. the first number

stored is the first number called when an

alarm occurs.

Select:1.

• Main Menu

• View / Modify

• Phone Numbers

Use the numeric keypad to select the 2.

desired phone number.

Select Phone Number

Phone Phone Phone Phone

1 2 3 4

Phone Phone Phone Phone

5 6 7 8

Back

Enter

Set the following parameters:3.

Phone Number 1

Type Home

Tel.#

Back

Phone 2

Type — Press Enter to select the type of sys-

tem associated with the selected number:

• Home — When this type of number is

called, the system delivers a voice mes-

sage describing the alarm condition.

• Cellular — When this type of number is

called, the system delivers a voice mes-

sage describing the alarm condition.

• Pager — When this type of number is

reached, the system sends a pager code

on the pager screen. The code is associ-

ated with the type of alarm. *Refer to the

following section to get further information

about the pager.

Telephone Number — Typ e i n th e p h on e n um -

ber. Special characters such as the Asterisk

(*) or Pound (#) can also be included in a

phone number. It is also possible to add one or

ma ny p au s es in t he di ali ng (the p aus e i s ide nti -

fied by letter “P” in the phone number):

Inserting pauses in a phone number —

Inserting a pause is useful if you need to

enter an access code to reach an external

phone line (e.g., if you have to dial “9” to

access the external phone line and then

have to wait 4 seconds before dialing the

number). Refer to section 4.3 to set the

delay associated with the Pause key.

4.5. Pager Setup

When a pager is paged, a code number is

displayed on the pager screen. The Agri-Alert

uses this number to transmit information to

the user. The code is displayed in the form

of a telephone number and contains the fol-

lowing information:

“SSS” is the identification number of the site

where the Agri-Alert is installed. The site

number is defined by the user and can contain

up to 32 digits. For example, if 2 Agri-Alert

controls are installed on separate sites, the

user can identify each site with a unique

code number.

“AAAA” is an alarm code

generated by the Agri-Alert.

If more than 1 alarm is ac-

tive, alarm codes are dis-

played one after the other.

In the example below, alarm

code 3000 identifies a test

call.

SSS Three-digit code of

the site where the alarm

occurred.

AAAA: Four-digit code

describing the type of

alarm.

Pager Code Components

PAGER CODE MEANING

1001, 1002, ... ,

1008

Alarm Zone 1, 2,

... , 8

3001 Test call

Problem

encoun-

tered

8001 Low battery

8002 16VAC failure

8005 Siren defect

8006 12VDC output defect

8010 High Noise alarm

8011 Outdoor probe failure

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Comentarios a estos manuales

Sin comentarios